Jeep Gladiator 2020 - Page 130

128 GETTING TO KNOW YOUR VEHICLE
6. Lower the windshield gently until it contacts the footman
loop bumpers (if equipped).
Footman Loop Bumpers
7. Secure the windshield by passing a cinch strap through
the
footman loops on either side of the hood and on the
windshield frame. Tighten the strap to secure the wind
-
shield in place.
ACC/FCW Sensor Protective Cover — If Equipped
Your vehicle may be equipped with a protective cover that is
t
o be
used whenever the windshield is folded down in order
to protect the ACC/FCW sensor. To install the cover, follow
the instructions below:
1. Secure the top part of the cover so that it hinges to the
head
er.
2. Swing the cover down and push on it so that it covers the
open
ing.
3. Check to make sure the cover is secured properly.
NOTE
:
Be sure to remove the cover before returning the windshield
t
o th
e normal position. Store the cover in the cargo area.
1 — Washer Nozzle
2 — Bumper
3 — Footman Loop
CAUTION!
Do Not Overtighten! Damage to the windshield could
resul
t.