184 GETTING TO KNOW YOUR INSTRUMENT PANEL
— Electronic Stability Control (ESC) OFF Warning
Light — If Equipped
This warning light indicates the Electronic Stability Control
(ESC)
is off.
Each time the ignition is turned to ON/RUN or ACC/ON/
RUN,
the ESC system will be on, even if it was turned off
previously.
— Loose Fuel Filler Cap Warning Light — If Equipped
This warning light will illuminate when the fuel filler cap is
loose
. Properly close the filler cap to disengage the light. If
the light does not turn off, please see an authorized dealer.
— Low Fuel Warning Light
When the fuel level reaches approximately 2.0 gal (7.5 L), this
light
will turn on and a chime will sound. The light will
remain on until fuel is added.
— Low Washer Fluid Warning Light — If Equipped
This warning light will illuminate when the windshield
washer
fluid is low.
— Engine Check/Malfunction Indicator Warning Light
(MIL)
The Engine Check/Malfunction Indicator Light (MIL) is a
p
art
of an Onboard Diagnostic System called OBD II that
monitors engine and automatic transmission control
systems. This warning light will illuminate when the ignition
is in the ON/RUN position before engine start. If the bulb
does not come on when turning the ignition switch from OFF
to ON/RUN, have the condition checked promptly.
Certain conditions, such as a loose or missing gas cap, poor
quali
ty fuel, etc., may illuminate the light after engine start.
The vehicle should be serviced if the light stays on through
several typical driving styles. In most situations, the vehicle
will drive normally and will not require towing.
When the engine is running, the MIL may flash to alert
serio
us conditions that could lead to immediate loss of
power or severe catalytic converter damage. The vehicle
should be serviced by an authorized dealer as soon as
possible if this occurs.
To Next Page
Loading...
