GETTING TO KNOW YOUR INSTRUMENT PANEL 185
— Service 4WD Warning Light — If Equipped
This warning light will illuminate to signal a fault with the
4WD s
ystem. If the light stays on or comes on during driving,
it means that the 4WD system is not functioning properly
and that service is required. It is recommend you drive to the
nearest service center and have the vehicle serviced immedi
-
ately.
— Service Forward Collision Warning (FCW) Light —
If Equipped
This warning light will illuminate to indicate a fault in the
Fo
rward
Collision Warning System. Contact an authorized
dealer for service.
Refer to “Forward Collision Warning (FCW) With Mitiga-
tion” in “Safety” for further information.
— Service Stop/Start System Warning Light — If
Equipped
This warning light will illuminate when the Stop/Start
s
ystem
is not functioning properly and service is required.
Contact an authorized dealer for service.
— Speed Control Fault Warning Light
This warning light will illuminate to indicate the Speed
Contr
ol System is not functioning properly and service is
required. Contact an authorized dealer.
— Sway Bar Fault Warning Light
This light will illuminate when there is a fault in the sway bar
disco
nnect system.
WARNING!
A malfunctioning catalytic converter, as referenced
above,
can reach higher temperatures than in normal
operating conditions. This can cause a fire if you drive
slowly or park over flammable substances such as dry
plants, wood, cardboard, etc. This could result in death
or serious injury to the driver, occupants or others.
CAUTION!
Prolonged driving with the Malfunction Indicator Light
(MIL)
on could cause damage to the vehicle control
system. It also could affect fuel economy and
driveability. If the MIL is flashing, severe catalytic
converter damage and power loss will soon occur.
Immediate service is required.
3
To Next Page
