SAFETY 205
Enabling SSC
SSC is enabled by pushing the SSC switch, but the following
cond
itions must also be met to enable SSC:
• The driveline is in 4L Range.
• The
vehicle speed is below 5 mp
h (8 km/h).
• The park brake is released.
• The
driver door is closed.
• The
driver is not applying throttle.
Act
ivating SSC
Once SSC is enabled it will activate automatically once the
foll
owing conditions are met:
• The driver releases the throttle.
• The
driver releases the brake.
• The
transmission is in any selection other than PARK.
• You
r vehicle speed is below 20 mp
h (32 km/h).
The set speed for SSC is selectable by the driver, and can be
adju
sted by using the gear shift +/-. Additionally, the SSC
set speed may be reduced when climbing a grade and the
level of set speed reduction depends on the magnitude of
grade. The following summarizes the SSC set speeds:
SSC Target Set Speeds
• 1
st = 0.6 mp
h (1 km/h)
• 2nd = 1.2 (2 km/h
)
• 3rd = 1.8 mph (3 km/h
)
• 4th = 2.5 mp
h (4 km/h)
• 5th = 3.1 mp
h (5 km/h)
• 6th = 3.7 mp
h (6 km/h)
• 7th = 4.3 mp
h (7 km/h)
• 8th = 5 mp
h (8 km/h)
• 9th = 5.6 mp
h (9 km/h) — if equipped
• REVERSE = 0.6 mp
h (1 km/h)
• NEUTRAL = 1.2 mp
h (2 km/h)
• PARK = SSC remains enabled but not active
NOT
E:
• During SSC, the +/- gear selector input is used for SSC
tar
get speed selection but will not affect the gear chosen by
the transmission. While actively controlling SSC, the trans
-
mission will shift appropriately for the driver-selected set
spee
d and corresponding driving conditions.
4
To Next Page
Loading...
