STARTING AND OPERATING 283
ENGINE START/STOP Button Functions — With Driver’s
Foot Off The Brake Pedal (In PARK Or NEUTRAL Posi-
tion)
The ENGINE START/STOP button operates similar to an
i
gnit
ion switch. It has three modes: OFF, ACC, and RUN. To
change the ignition modes without starting the vehicle and
use the accessories, follow these steps:
1. Starting with the ignition in the OFF mode.
2. P
ush the ENGINE START/STOP button once to place the
igni
tion to the ACC mode (instrument cluster will display
“ACC”).
3. Push the ENGINE START/STOP button a second time to
pla
ce the ignition to the RUN mode (instrument cluster
will display “ON/RUN”).
4. Push the ENGINE START/STOP button a third time to
ret
urn the ignition to the OFF mode (instrument cluster
will display “OFF”).
AutoPark
AutoPark is a supplemental feature to assist in placing the
vehi
cle in PARK should the situations on the following
pages occur. It is a back up system and should not be relied
upon as the primary method by which the driver shifts the
vehicle into PARK.
The conditions under which AutoPark will engage are
outl
ined on the following pages.
WARNING!
• Driver inattention could lead to failure to place the
vehi
cle in PARK. ALWAYS DO A VISUAL CHECK
that your vehicle is in PARK by verifying that a solid
(not blinking) “P” is indicated in the instrument cluster
display and on the gear selector. If the "P" indicator is
blinking, your vehicle is not in PARK. As an added
precaution, always apply the parking brake when
exiting the vehicle.
• AutoPark is a supplemental feature. It is not designed
to r
eplace the need to shift your vehicle into PARK. It is
a back up system and should not be relied upon as the
primary method by which the driver shifts the vehicle
into PARK.
5
To Next Page
Loading...
