Jeep Gladiator 2020 - Page 286

284 STARTING AND OPERATING
If the vehicle is not in PARK and the driver turns off the
engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
• V
ehicle is equipped with an 8-speed transmission
• Dri
ver door is ajar or in conditions where driver door is
rem
oved an additional trigger would be if the driver is off
the seat (seat pad sensor detects driver missing)
• Vehicle is not in PARK
• Veh
icle Speed is 0 mp
h (0 km/h)
• Ignition switched from RUN to OFF
NOT
E:
For Keyless Go equipped vehicles, The engine will turn off
and
the ignition will change to ACC mode. After 30 minutes
the
ignition switches to OFF automatically, unless the driver
turns the ignition OFF.
If the vehicle is not in PARK and the driver exits the
vehic
le with the engine running, the vehicle may Auto-
Park.
AutoPark will engage when all of these conditions are met:
• V
ehicle is equipped with an 8-speed transmission
• Dri
ver door is ajar or in conditions where driver door is
rem
oved an additional trigger would be if the driver is off
the seat (seat pad sensor detects driver missing)
• Vehicle is not in PARK
• Dri
ver door is removed
• Veh
icle speed is 1.2 mp
h (2.0 km/h) or less
• Driver seat belt is unbuckled
• Dri
ver door is ajar
• Bra
ke Pedal is not depressed
The
MESSAGE “AutoP
ark Engaged Shift to P then Shift to
Gear” will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be displayed in the
i
nst
rument cluster. In these cases, the gear selector must be
returned to “P” to select desired gear.
If the driver shifts into PARK while moving, the vehicle
may A
utoPark.
AutoPark will engage ONLY
when vehicle speed is 1.2 mph
(2.0 km/h) or less.