94 GETTING TO KNOW YOUR VEHICLE
NOTE:
Ensure the wire harness is not tucked under the belt rail or
betwee
n the belt rail and the door rail.
Incorrect Placement Of Wire Harness
6. Install the door frames. Start with both front doors,
foll
owed by both rear doors. Refer to “Door Frame Instal-
lation” in this section for instructions and appropriate
t
orqu
e specifications for the door frame Torx head
fasteners.
7. Unsnap and remove the storage bag. This bag should be
disc
arded. It was intended as a protective cover for ship-
ping only.
8. E
nsure the top is secured with the provided
hook-
and-loop fasteners, then lift the soft top onto the
rear of the cab. Line up the locater pins (one on each side
of the soft top) with the rear door frames.
CAUTION!
Failure to follow the next steps could result in damage to
the s
oft top or vehicle.
To Next Page
Loading...
