Jonker Sailplanes JS3 RES - Maintenance Schedule; Annual Inspection; Table 4-1 Maintenance Requirement Schedule

JS-MD 3 RES Maintenance Manual
Supplement
MD11-AMM-00-002
Issue: 00
Rev. 00
Rev. Date: 23-May-22
Page 4-1
4 MAINTENANCE SCHEDULE
WARNING: Before any maintenance, the HV batteries should be removed.
WARNING: Only OEM and authorised organisations are allowed to maintain high voltage
components.
Annual inspection
A mandatory annual inspection is required for issuing the Airworthiness Review Certificate.
NOTE: Some regulating authorities require one-year or 100 hour-interval inspections.
General inspection guidelines
• Inspect all bolted connections and locking devices i.e. locknuts, split pins, etc.
• Check all metal parts for adequate greasing and rust prevention.
• Check for signs of damage
Use the inspection checklist given in APPENDIX A – Annual inspection checklist to perform
the annual inspection. The maintenance requirements schedule is illustrated in Table 4-1.
* Whichever comes first (Refer to Appendix A on the Annual inspection checklist.)
Who may perform
the Maintenance
Maintenance interval
OWNER
Every 2 years
AMO
Every 300 engine hours or 15 years
AMO
Every 100 engine hours or annually
OWNER
Every 25 hours
Maintenance requirements
Motor overhaul by manufacturer (Refer to Solo 80400 manual)
X
Controller fan replacement (Refer to section 4.11.1.2.3)
X
Controller check (Refer to Solo manual)
X
System Annual Inspection (Refer to APPENDIX A – Annual inspection
checklist)
X
Propeller & functional check ( Refer to section 4.4.2 and Solo 80400
manual)
X
Propeller overhaul by manufacturer
X
Replace fire warning 9 V battery (Refer to section 4.17)
X
Table 4-1 Maintenance Requirement Schedule