Need help?Do you have a question about the JR ProPo XG8 and is the answer not in the manual?
General| Brand | JR |
|---|---|
| Model | ProPo XG8 |
| Category | Remote Control |
| Language | English |
Details precautions for the 2.4GHz band, potential interference, and safe operation practices.
Details warnings about product impact, hazardous locations, and specific operational risks.
Covers DANGER, WARNING, CAUTION for battery/charger use, including charging and handling.
Explains how to charge the transmitter's Li-Fe battery using the AC adapter, including precautions.
Explains how to switch between various aircraft settings using one-touch operations via switches.
Allows switching control surface angles and curves using Dual Rate switches and exponential settings.
Adjusts servo control surface angles for each channel separately in left/right and up/down directions.
Provides fine adjustment for servo horn mounting angle when it's not 90 degrees.
Reverses the servo operating direction (pulse change direction) for each channel.
Slows down the operation speed of servos for each channel, acting as a speed limiter.
Adjusts servo operation in response to throttle stick, allowing 5-point curve settings and exponential.
Adjusts pitch action in response to throttle stick, allowing 5-point curve settings and exponential for helicopters.
Provides examples of Pitch Curve and Throttle Curve settings in aerobatic specifications.
Mixes pitch and tail servo for revolution mixing, allowing setting of mixing amounts and rate.
Controls gyro sensitivity using GEAR and AUX channels, allowing transmitter adjustment and dual gain.
Maintains rotor rotation speed at a uniform value, allowing separate settings for each Flight Mode.
Corrects rotor rotation reduction due to loading by mixing control surfaces like ailerons, elevators, and rudder.
Sets Throttle Trim movement and provides Throttle Cut/Trim Memory functions for engine cutting.
Function for autorotation landing, fixes Throttle Servo at engine cut position, with Stick Auto function.
Sets mixing for swash plates with 1-4 servo units, used for CCPM systems, with E-ring function.
Controls flaps in three stages, includes elevator mixing, and an Auto Throttle function.
Function for easily carrying out Snap Rolls with presets and stick switches for automatic activation.
Mixes aileron operation to wing root flaps to minimize air resistance during roll rate increase.
Displays a warning screen if Throttle Stick or Flight Mode switches are set to dangerous positions upon power-on.
Moves servos to preset optional positions when the receiver loses radio waves from the transmitter.
Carries out binding (pairing) with the receiver and reduces output for range checking.
Details warranty terms, repair procedures, and cautions regarding product usage and data.
To Next Page
