To Next Page

To Previous Page

Section 4 Operation

Navigation Mode Operations

• The Trip Log modes (STD/NAV1, STD/NAV2) provide GOTO,

EVENT and WAYPOINT skip functions to facilitate navigation

when you navigate to stored waypoints or you navigate from a route

plan list. You can use these functions with soft keys dedicated to this

mode.

These functions and operations are described below.

GOTO Selected Waypoint

•You can use this function to enter the NAVIGATION mode when

you navigate directly to a stored waypoint.

•Push

to display the WAYPOINT list. Press the up

or down to select a waypoint. Push the in to open the

GOTO WPT xxx. Push the in again to set the waypoint and

activate the NAVIGATION mode. Select NO and push the

in to cancel the waypoint and return to the WAYPOINT list.

Note:

You cannot change the AUTO mode when the NAVIGATION mode

is activated.

Store an Event

•You can use this function when you want to store the current position

of your vessel to the WAYPOINT list.

•Push the

in to display the WAYPOINT list. An unoccupied

WAYPOINT number is selected automatically. When all

WAYPOINT numbers are occupied, WAYPOINT number 001 is

selected. Select another number if you do not want to overwrite

WAYPOINT number 001. Push the in to display the

current position of your vessel in the pull-down menu. Press the

up or down, or to the left or right, to enter the WAYPOINT

name. Push the in to store the WAYPOINT.

JRC FF50 User Manual

Other manuals for JRC FF50