Section 4 Operation
59
Menu Opening
•Push to display the Top menu. Push in the
NAVIGATION mode to skip the Top menu and display the
NAVIGATION menu. To close all menus, push while any
menu is open.
•Refer to “Menu operations” p.60 for details about menu operations.
Storing and Resetting Custom Data
•You can use this function when you want to store the normal
operating status as a CUSTOM DEFAULT and reset all set values
using CUSTOM DEFAULT. If you make a mistake in operation or
any set value is changed accidentally, you can easily recall the original
status using this function.
•Push
to open the CUSTOM RESET menu. Select YES and
push the in to replace all set values with the CUSTOM
DEFAULT values. Select NO and push the in to abort
initialization.
•Push
twice to open the PRESET menu. Select YES and
push the in to store the currently set values as the
CUSTOM DEFAULT values. Select NO and push the in to
abort storing.
Note:
The WAYPOINT information and ROUTE information are not
stored in memory. When you do the master reset, values at the factory
are entered as CUSTOM DEFAULT values.
To Next Page
Loading...
Need help?
General
