Section 4 Operation
58
Follow the Route Plan
•You can use this function when you activate the NAVIGATION
mode according to the navigation plan stored previously.
•Push to open the NAVIGATION menu. Select FOLLOW
ROUTE and push the in to open the pull-down menu in
which you select a route and trace direction. Press the up or
down to select a route number and press it to the right or left to select
a trace direction. When you select FWD for the trace direction, the
navigation is performed in the ascending order of the numbers
(1,2,3,...) of the waypoints stored in the navigation list. When you
select REV, your vessel will navigate in the descending order of the
waypoint numbers (...3,2,1). Finally, push the in to open
the CONFIRMATION message. Select YES and push the
in to start the navigation route plan. Select NO and push the
in to return to the NAVIGATION menu.
Skip the Waypoint
•You can use this function when you want to skip a WAYPOINT and
go to the next WAYPOINT while NAVIGATION is activated.
Push the
to change the WAYPOINT currently displayed on
the NAVIGATION screen to the next waypoint.
Note:
You cannot change the gain while the NAVIGATION mode is
activated.
Discontinue to Follow the Route plan
You can use this function when you want to abort NAVIGATION.
During the NAVIGATION operation, push and hold for
more than 3 seconds to display a message relating to the abortion of
NAVIGATION in the center of the screen. Press the joystick to the left
or right to select YES and push it to delete the message. Select NO and
push joystick to continue NAVIGATION.
To Next Page
Loading...
Need help?
General
