Section 4 Operation
85
Master Reset and Language Select
Operation
•A MASTER Reset can be performed by either the SOFT Reset or
HARD Reset. The SOFT Reset restores all set values except the
WAYPOINT data and ROUTE PLAN data to the original factory
set-up values. The HARD Reset restores all set values to the original
factory- set values and deletes the WAYPOINT and ROUTE PLAN
data. When you want to keep the WAYPOINT and ROUTE PLAN
data, execute the SOFT reset. When the MASTER reset is executed,
the CUSTOM DEFAULT is initialized to the factory-set default
settings.
• When you push
to turn the power on while pushing
and at the same time, the LANGUAGE SELECT
display appears. Press the up or down to select a language
and push it in to open the MASTER RESET type select display. Press
the up or down to select HARD or SOFT and push it in to
select OK or CANCEL for the selected language and the reset type.
Press the to the left or right to select OK and push it in to
execute the MASTER reset. Select CANCEL and push the
in to return to the language select display. After the MASTER reset is
executed, the FF50 is rebooted automatically. To abort the MASTER
reset, turn the power off and then turn the power on again.
Note:
When a backup error occurs, the FF50 enters the MASTER Reset
mode automatically, and the language select menu opens. In this case,
you cannot abort the MASTER reset. Be sure not to turn the power
off during the MASTER reset.
To Next Page
Loading...
Need help?
General
