Chapter 2
OPERATIONS
2.14
FUNCTION KEY SETTINGS
2-113
2
INSTRUCTION MANUA
Calling functions
1 Press the [FUNC] key.
Each time you press the [FUNC] key, the setting is cyclically changed in order of:
)XQFWLRQRIIĺ)XQFWLRQ6HWWLQJĺ)XQFWLRQ6HWWLQJĺ)XQFWLRQ6HWWLQJ
ĺ)XQFWLRQ6HWWLQJĺ)XQFWLRQRII
The currently called function mode is indicated as the right of the screen.
z Calling function setting menu
1 Hold down the [FUNC] key.
"Function Setting" menu appears when holding down the [FUNC] key.
Changing the setting
z Temporarily changing the setting
y When radar signal processing setting is changed by using the soft key or the menu
operation while function 1 to 4 is called, the change is temporarily reflected to the
operating state.
y Since this method does not change the memory contents, the new setting is deleted as
soon as another function is called.
y When the previous function is called again, operation is performed according to the
memory contents.
z Changing memory contents
y To change the memory contents of functions 1 to 4, use [Function Setting] in the
Main Menu.
To Next Page
Loading...
Need help?
General
