JD-1307-05 Attachment 1 8/11
CFG-296
TB１
Connect antenna wire
Connect control cable.
Connect copper plate.
Connect RF cable.
CDJ-2960
1: Red +12V
2: Black E
3: Green TXD
4: White RXD
5: Yellow PA_MUTE
6: Gray ANT_CURR
TB2
Connection of CDJ-2960
4. Connect the control cable, antenna wire, copper plate and RF cable disconnected in the paragraph 3.
5. Return the upper cover of NFC-296.
Note
(a) Confirm connections of cables and connector before
returning the upper cover.
(b) Screw the upper cover in order of figure.
(The standard of tightening torque is 15 kgf･cm.)
6. Return the shade cover and earth wire.
Replacing the CFG-296 Matching Unit in the NFC-296 is finished.
1
23
4
5 6
To Next Page
Loading...
