4.5.2.3 Calling Frequency settings
Set the frequency to a maximum of six channels, [1] through [6].
Procedure
(a) Press from the “SETUP” display and then press .
3 ENT
SETUP Select no.
1.Date&time edit
CALLING FREQUENCY REGISTRATION (TX/RX)
[1] 12,345.6/12,356.7 kHz ( )
[2] NONE / NONE kHz ( )
[3] NONE / NONE kHz ( )
[4] NONE / NONE kHz ( )
[
5] NONE / NONE kHz ( )
[6] NONE / NONE kHz ( )
Use and to scroll.
The “CALLING FREQUENCY REGISTRATION (TX/RX)” display appears.
(b) Using the number keys and , input the “TX frequency”/“RX frequency” for each channel.
Input a name into ( ) and then press .
To skip the name input or to move to the next item, press again.
Use / to select a character in ( ). When “D” is displayed, pressing displays
“E”, “F” and so on, and pressing displays “C”, “B”, and so on.
To enter the alphanumeric character input into ( ), press after input of each
character.
(c) After input in complete, press and then (SAVE) .
The following display appears.
Press to tune the tuner and then return to the "SETUP" screen.
Press to abort tuning and return to the "SETUP" screen.
Press and then (QUIT) to cancel the set contents and end the setting
operation.
2.Position edit
3.Calling frequency registration
4.Address registration
5.Distress setup
Use and to scroll.
6.Others alarm setup
7.Automatic acknowledgement setup
8.Scanning setup
▲
▼
9.Watchkeeping receiver setup
▲
▼
ENT
ENT
FUNC
ENT
ENT
9
Tune regist frequency?
[ENT] key ：TUNE
[STOP] key：NO TUNE
ENT
STOP
FUNC
4
Note
Note
58
To Next Page
Loading...
