4.5.5 Operation Check
After installation, execute the operation check with the self-diagnosis function.
Procedure
(a) Confirm that the “DSC watching” display appears.
The “DSC watching” display appears when the power is turned on. Almost all
operations start from this display. This display also returns when each mode is closed.
(b) Press .
The “MENU #1” display appears.
DSC watching 06.Sep.2001(Thu) 01:26
N12’34 E123’45 SPEED:12.4KT at 01:26
Self-ID = 000000000 [UTC]
MENU
Note
(c) Press .
The “MENU #2” display appears.
MENU
(d) Select “4.Self test” and press .
The “Self test” display appears.
(e) Select “1.Modem loop test” and press .
The modem loop test starts.
(f) After 10 seconds, “OTHERS” LED blinks in the front panel. Press , the “RECEIVED
MESSAGE” display appears.
ENT
MODEM LOOP TEST
STOP
RECEIVED MESSAGE
RX date&time : 06.Sep.2001(Thu) 01:26
Format :INDIVIDUAL
Address :xxxxxxxxx
ENT
Category : ROUTINE
Telecommand-1 : J3E TEL
Telecommand-2 : NO INFORMATION
Work TX/RX freq : 12,346.5kHz/12,346.5kHz
End of sequence : EOS
Rx frequency : . kHz
62
To Next Page
Loading...
