4.5 NCT-196N DSC/NBDP Modem
4.5.1 Self ID, Navigation and Radiotelephone Setting
The settings described in this section have been made prior to shipment from the factory.
ATTENTION
To enable setting adjustment, remove the cover of the NCT-196N DSC/NBDP MODEM
and insert the switch(S1)-No.3 into the OFF. When adjustment is complete, re-insert
the switch(S1)-No.3 into the ON and replace the cover.
S1
Insert the S1-3 to
OFF at the time of
Self-ID setting.
S1
Re-insert the
S1-3 to ON after
Self-ID setting.
OFF
12345678
OFF
12345678
Dip switch setting
Note
Switch No. Function Default setting
S1-1 Modem function ON: DSC only, OFF: DSC and NBDP OFF
S1-2 EEPROM initialize ON: Disenable, OFF: Enable (expect ID) ON
S1-3 EEPROM writing ON: Disenable, OFF: Enable ON
S1-4 TEST signal sending ON: Disenable, OFF: Enable OFF
S1-5 AF signal wait ON: Normal, OFF: Factory setting ON
S1-6 HT signal using ON: Not use, OFF: Use ON
S1-7 - ON
S1-8 - ON
Procedure
(a) Both press and “POWER SWITCH” to access the following the “INSTALLATIONSETUP”
menu.
MENU
INSTALLATION SETUP
Self-ID : 111111111
Group-ID : 022222222
Navigation : NMEA0183
Serial cont: ON
Data clear : OFF
SPACE signal send
MARK signal send
DOT signal send
70-TIME MESSAGE send
WKR frequency : 2,187.5
WKR step test
History
54
To Next Page
Loading...
