Attached documents 2 (1)
5/23
Checking JSB-196/JSB-196GM channel data
Nov 5, 2004
In upgrading the software of JSB-196/JSB-196GM from 2.9 or earlier to Ver3.0 or later, be sure to
record the data of channels in the following procedures. And after upgrading, input these channels
according to the attached documents 2 (2) "Setting of JSB-196/JSB-196GM user channel”.
Procedure
(1) In case of JSS-296/596/896, turn ON the AC switch of NAH-692/695/698. In case of JSB-196/
JSB-196GM, turn ON the DC power supply.
(2) Press both MENU and POWER to access the level
2 menu of JSB-196/JSB-196GM.
TX FREQ
RX FREQ
GRoUP 1
25,070.0 kHz
AGC
26,145.0 kHz
TEL
RDY
TX FREQ
RX FREQ
USR- 1
4,500.0 kHz
AGC
4,200.0 kHz
TEL
RDY
TX FREQ
RX FREQ
USR- 1
4,500.0 kHz
AGC
4,200.0 kHz
TEL
RDY
TX FREQ
RX FREQ
USR- 2
6,500.0 kHz
AGC
6,200.0 kHz
TEL
RDY
(3) Press CH and turn the dial to select the channel
group. (JSB-196/JSB-196GM has 10 groups and
each group has 20 channels. “Group 1” may be
changed to other name. In this case, record each
group name.)
(4) Press ENT to select the group.
The first channel of the selected group will be
displayed.
(5) Turn the dial to select the channel.
Record channel name, TX/RX frequencies and
mode.
(6) Press MENU, 3, 5, ENT to select the ADJPOWER
menu.
The TX power level is displayed on the right of LCD
so record it.
(7) Press MENU to exit the ADJPOWER menu.
(8) Turn the dial to select the next channel.
Record the all channel data in the same procedure.
(9) In case of JSS-296/596/896, after recording the all
channel data, turn off the AC switch and turn on the
DC switch.
Record channel data again according to the
procedure from (2) to (8).
JSB-196/JSB-196GM LCD
TX FREQ
RX FREQ
ADJPoWER
4,500.0 kHz
AGC
4,200.0 kHz
115
RDY
To Next Page
Loading...
