JRC JSS-296 - NMEA0183 Format; Transmission Format; Data Format; JRC Format

(b) Select “Self-ID” using / , input the Self-ID (9-digit) using the number keys and
press .
▲
▼
ENT
(c) If a Group-ID is assigned, select “Group-ID” using / , input the Group-ID (8-digit) and
press .
▼
▲
ENT
(d) Select “Navigation” using / , specify the navigation data format using / and
press
.
ATTENTION
(e) Select “Serial cont” using / , specify “ON” using / and press .
(f) Press and then (SAVE). The contents of the settings are written to memory
(saved) and the “DSC watching” display returns. This completes the operation setting.
Press and then (QUIT) to cancel the set contents and end the setting operation.
▼
▲
▼
▲
ENT
FUNC
9
FUNC
4
ENT
There are two types of navigation data formats, NMEA 0183 and JRC format. Fo
r
normal operation, specify NMEA 0183.
NMEA0183 format
(A) Transmission format
Transmission method: Asynchronous
baud rate : 4800bps
Start bit : 1bit
Data bit : 8bit
Stop bit : 1bit
Parity : None
(B) Data format
GLL : Position data ( Lat / Lon ) and UTC time data (IEC61162-1)
Position data ( Lat / Lon ) (NMEA Version 1.5)
ZDA : UTC time data and date ( year, month, day ) data (IEC61162-1)
ZLZ : UTC time data (NMEA Version 1.5)
ZZU : UTC time data (NMEA Version 1.5)
VHW : Water speed and heading data (IEC61162-1)
VTG : Course over ground and ground speed (IEC61162-1)
RMC : Position data ( Lat / Lon ), UTC time data,
and ( year, month, day ) data (IEC61162-1)
JRC format
(A) Transmission format
Transmission method: Asynchronous
baud rate : 1200bps
Start bit : 1bit
Data bit : 8bit
Stop bit : 2bit
Parity : None
(B) Data format
“F” or “D” +80H : Position ( Lat / Lon ), date ( year, month, day ) data and time data, “@”
+80H.
Note
If a time difference is set on JRC format navigation equipment, local time, not UTC
time, is output. Set the time difference to zero or use the NMEA0183 format.
Note
55