JRC JSS-296 - Scanning Frequency Settings

4.5.2.2 Scanning Frequency settings
Set the frequency to a maximum of six channels, [1] through [6].
Procedure
(a) Press from the “SETUP” display and then press .
8
ENT
SETUP Select no.
SCANNING FREQUENCY REGISTRATION (TX/RX)
[1] 1,610.0 / 1,615.0 kHz
[2] 2,000.0 / 2,000.0 kHz
[3] 3,000.0 / 3,000.0 kHz
[4] 4,208.0 / 4,219.0 kHz
[5] 5,000.0 / 5,000.0 kHz
[6] 6,000.0 / 6,000.0 kHz
Use and to
scroll the screen.
The “SCANNING FREQUENCY REGISTRATION (TX/RX)” display appears.
(b)
Using the number keys, perform the frequency input for each channel in the following
order, “TX frequency”, , “RX frequency”, .
To channel the settings for previously set items, press and then press .
(c) After input in complete, press and then (SAVE) .
The following display appears.
Press to tune the tuner and then return to the "SETUP" screen.
Press to abort tuning and return to the "SETUP" screen.
Channels 201-206 of the JSB-196GM Radiotelephone are allocated for scanning of the
registered frequencies.
1.Date&time edit
2.Position edit
3.Calling frequency registration
4.Address registration
5.Distress setup
Use and to scroll.
6.Others alarm setup
7.Automatic acknowledgement setup
▼
▲
8.Scanning setup
9.Watchkeeping receiver setup
▲
▼
ENT
ENT
CLR
ENT
Note
FUNC
9
Tune regist frequency?
[ENT] key ：TUNE
[STOP] key：NO TUNE
ENT
STOP
Note
57