JRC JSS-296 - RF Cable; Connecting the Antenna; Wrapping RF Cable

RF Cable
Use the connector to connector the high frequency cable and after sealing with self-fusion tape, wrap
with vinyl tape.
ANTENNA TUNER
After connecting the connector, steal
with self-fusion tape and then wrap
with vinyl tape.
SELF-FUSION TAPE:
Wrap a min. of five layers using the
overlap technique as shown.
VINYL TAPE:
Wrap a min. of three layers using the
overlap technique as shown.
Wrap
Figure 3-10 Wrapping RF Cable
Connecting the Antenna
Use the tension-absorbing insulator to connect the lead-in antenna cable as shown in figure 3-8. To
connect the lead-in antenna cable and the antenna tuner terminal, first insert the cable through the
terminal hole and then, after making a loop, affix with a bolt and a wire clip. Secondly, secure the end
of the cable with a nut. If the cable is connected without a loop formation, the cable may become
disconnected or severed.
LOOP ( 100- 150)
WIRE CLIP
LEAD-IN ANTENNA CABLE
CABLE END
(TERMINAL CONTACT)
BOLT
NUT
ANTENNA TUNER TERMINAL HOLE
Necessary to prevent severing of the
cable (tension-absorbing)
Figure 3-11 Connecting antenna cable
27