JSB-196/JSB-196GM Upgrading Procedures (JD-1301-04)
Nov 5, 2004
1. Preparation
1.1 Checking of JSB-196/JSB-196GM, NCT-196N, and NDZ-127J software versions.
Check the software versions according to attached document 1 “Checking of JSB-196
/JSB-196GM, JSS-296/596/896 software versions”. If software versions are the
following versions, upgrade software according to this procedures.
JSB-196/JSB-196GM： TRX Ver3.6 or earlier, DSP Ver1.7 or earlier
NCT-196N: IC2 Ver2.12 or earlier, IC204 Ver2.11 or earlier,
IC402 Ver2.11 or earlier, IC407 Ver2.10 or earlier
NDZ-127J: U28 Ver2.10 or earlier
1.2 Item for upgrading
1.2.1 Program files
(1) Download the following file from the Homepage of the MARINE SERVICE
DEPARTMENT.
JSB-196/JSB-196GM, JSS-296/596/896 software: file name “JSS_041105.exe”
(2) Execute the downloaded file (“JSS_041105.exe”).
The following files are retrieved.
JSB-196/JSB-196GM: TRX Ver3.7 file name ”196_V372.hex”
NAH-692/695/698： Ver3.2 file name “nah_V320.hex”
NCT-196N： IC2 Ver2.12 file name “nct_ic2_V212.hex”
IC204 Ver2.11 file name “nct_ic204_V211.hex”
IC402 Ver2.11 file name “nct_ic402_V211.hex”
IC407 Ver2.10 file name “nct_ic407_V210.hex”
NDZ-127J： U28 Ver3.01 file name “ndz_u28_V301.bin”
Updating program Ver1.00 file name “JSSflash_V100.exe”
1.2.2 In the case of JSB-196/JSB-196GM
・
JSB-196/JSB-196GM TRX Software Ver3.7 file name ”196_V372.hex”
・ Modification Kit (JRC code: 7DEJD0319)
・ Soldering iron ( for replacement of capacitor and chip resistor)
・ Personal computer with RS-232C port (OS: Windows95/98/2000/XP)
・ D-sub cross cable (Connector type: 9pin, female-female)
D-sub 9pin Female cross cable
1/23
To Next Page
Loading...
