EasyManua.ls Logo

JRC JSS-296 - Page 190

JRC JSS-296
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2/2
Priority A: Carry out immediately
B: Carry out at periodical inspection
× C: Carry out upon client’s request
D: Information and news
1. Subject
Software upgrading
2. Objective Equipment
JSB-196/JSB-196GM Radio Telephone of the following Serial Number at software version 3.6 or
earlier.
(JSB-196GM-R (JSB-196GM for NCH-1961/1962) is not an object)
Serial Number: BS53500-BS58107
Note: If the software of NCT-196N and NDZ-127J are following versions, upgrade them.
NCT-196N: IC2 Ver2.11 or earlier, IC204 Ver2.11 or earlier, IC402 Ver2.11 or earlier,
IC407 Ver2.10 or earlier
NDZ-127J: U28 Ver2.10 or earlier
3. Outlines
Problem:
Transmission of Mark signal may be missed if high-speed MORSE communication is performed in
CW mode.
An audio output will become small if the NOISE REDUCTION is turned ON.
SQUELCH may remain closing on a receiving level, since the step of SQUELCH level is large.
Countermeasure:
Upgrade the software according to attached document “JSB-196/GM Upgrading procedures (JD-
1301-04)”. Moreover, replacement of ROM and parts on TRX UNIT (CMN-1960/CMN-1960-S) are also
required. Therefore get the following Modification kit from the SERVICE GROUP (PARTS TEAM) of
MARINE SERVICE DEPARTMENT and replace them.
Modification Kit (JRC code: 7DEJD0319)
Contents: ROM 7DEJD0289C (DSP ROM Ver1.7) 1 piece
Capacitor ECEA1EKS4R7 (4.7uF, 25V) 1 piece
Resistor ERJ6GEYJ224V 220k ohm (2012 chip) 1 piece
4. Attached document
JSB-196/JSB-196GM Upgrading Procedures (JD-1301-04)

Table of Contents

Other manuals for JRC JSS-296

Related product manuals