– 49 –
2-3. Basic operation of the operation panel and the basic operation for sewing
1. Turning ON the power switch
When you turn ON the power to the sewing machine, the main screen P1 is displayed.
In the case no sewing pattern (graphic data) is stored in the internal memory, the message "No sewing
pattern exists in the internal memory" is displayed after the power has been turned ON. When you press the
key at this time, the message screen disappears and the screen is restored to the main screen.
2. Sewing pattern to be sewn
The pattern you have selected is displayed on the main screen P1. When you want to change the sewing
pattern (sewing data), refer to "II-3-2-4-1. Reading sewing patterns" p. 51.
3. Starting sewing
①
Before starting actual sewing, re-check the settings of sewing conditions. Set the sewing machine speed
in the range of 200 and 3,000 sti/min.
②
The sewing machine speed is determined by the set value of speed and stitching pitch. The sewing speed
automatically limits the sewing machine speed according to the set value of stitching pitch.
③
Place a material on the template. Place this template in the cassette clamp device. Lower the cassette
clamp by pressing cassette clamp switch
Ⓐ
on the operation panel.
The sewing machine starts sewing when you press start switch
Ⓑ
on the operation panel. After the com-
pletion of sewing, the sewing machine automatically stops running and the cassette clamp automatically
goes up.
Do not change the set value of speed while the sewing machine is performing sewing. (Excluding
the case that the sewing machine temporarily stops during sewing.)
Ⓐ Ⓑ
⇨
To Next Page
Loading...
