– 65 –
No. Description of message Item to be checked
M-001 UP counter reaches set value. Press the Enter key.
M-002 DOWN counter reaches set value. Press the Enter key.
M-003 Not at origin, cannot operate. Return to origin rstly.
M-004 Pattern data not exist. Please reload or input again.
M-005 Set value is too large. Please input value within valid range.
M-006 Set value is too small. Please input value within valid range.
M-007 Please press the "Origin return key".
M-008 Save parameter is abnormal. Press the Enter key to restore the default values.
M-009 Cannot nd pattern in memory. Press the Enter key to load the default patterns.
M-010 Memory full Please delete the idle sewing data.
M-011 Delete pattern data from memory?
M-012 Replace pattern data in memory?
M-013 Can not delete pattern data. The selected sewing data is being used.
M-014 Format memory? All the patterns within the memory will be deleted.
M-015 Communication error Abnormal event occurs in the communication between the
operation panel and the control box. Please turn OFF the
power and check it.
M-016 Beyond sewing range. Make sure pattern data is in sewing range.
M-017 Fail to load letter sewing le.
M-018 Operation panel not match to machine type. Please check the model and the software version.
M-019 Low memory Please delete the unused pattern data.
M-020 Wrong pattern number Please input the right pattern number.
M-021 Beyond max stitch interval.
M-022 Wrong password Please input password again.
M-023 Hardware clock error The hardware clock has problem, please contact
manufacturer for repair.
M-024 Stitch number beyond range Please reduce stitch number.
M-025 Inputted stitch interval is too small. Please input value within valid range.
M-026 Inputted stitch interval is too large. Please input value within valid range.
M-027 2nd origin existed Please check the 2nd origin setting.
M-028 Operation setting value is out of range. Please input value within valid range.
M-029 Please press the Origin return key to return to
origin.
M-030 Copy the pointed pattern?
M-031 Copy all pattern data?
M-032 Restore to default setting?
M-033 USB is not connected. USB is pulled out.
M-034 Cannot nd pattern data in USB.
M-035 At least input one letter. At making pattern of letter sewing, user has to input at least
one letter.
M-036 No alarm record
M-037 Replace needle. Reach set value for needle replacement, please replace
needle.
M-038 Replace oil. Reach set value for oil replacement, please replace oil.
M-039 Clean machine. Reach set value for cleaning machine, please clean
machine.
M-040 Different data format Please conrm the data format.
M-041 Cannot create curve. Please input again according to the standards of curve input.
5. MESSAGE LIST
To Next Page
Loading...
