Mode [Switched / Redundant]
Redundant – The interface will duplicate the audio traffic to both
Ethernet ports.
Switched – The second port behaves like a standard switch port
allowing daisy-chaining through the interface. I.e. IP
configuration is only available for Redundant mode.
Important Note! When set to switched mode, do not connect both ports to the same network
(same Ethernet switch) if it does not support STP (Spanning Tree Protocol). This is the case for most of
the off-the-shelf (office) switches. Doing so will cause a race condition where IP packets are circling around
from the external switch to the second Dante (switch) port and back via the first port. This will tear down
your network and may create a bunch of new "friends" in your facility.
Primary Address Setup Setup of the primary network interface
Network Status [Offline / Connected + bandwidth]
DHCP – Automatic IP Config. [OFF / ON]
IP-Address
Netmask
DNS Server
Gateway
MAC Address
Secondary Address Setup Setup of the secondary network interface
Network Status [Offline / Connected + bandwidth]
DHCP – Automatic IP Config. [OFF / ON]
IP-Address
Netmask
DNS Server
Gateway
MAC Address [unknown / address]
To Next Page
Loading...
