Setup GUI – EVENTS – Events – Measurement Events
The measurement event as part of an action can control the integrated measurement of the processed
programs:
For each measurement event you can assign one of the possible control functions.
In the example above the measurement event "Loudness Reset" calls the "Reset" command.
Setup GUI – EVENTS – Events – I/O Events
At the moment I/O events are limited to control the GPOs of the D*AP4:
Each GPO (when incorporated into that I/O event) can be set to the behavior as follows:
^clear Turns a GPO off that was previously turned on.
set Turns a GPO on.
follow The GPO follows the state of the trigger.
toggle The trigger will toggle that GPO.
Be careful because it needs a definite known starting condition to work
properly.
To Next Page
Loading...