•
Before lifting or moving the switch, disconnect all external cables.
Related
Documentation
General Safety Guidelines and Warnings on page 155•
• Installation Instructions Warning on page 165
• Mounting an EX2200 Switch on page 74
Ramp Warning
This topic applies to hardware devices in the EX Series product family, which includes
switches and the XRE200 External Routing Engine.
This topic also applies to hardware devices in the QFX Series.
WARNING: When installing the device, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaistakaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related
Documentation
General Safety Guidelines and Warnings on page 155•
• Installation Instructions Warning on page 165
• Grounded Equipment Warning on page 172
Rack-Mounting and Cabinet-Mounting Warnings
This topic applies to hardware devices in the EX Series product family, which includes
switches and the XRE200 External Routing Engine.
This topic also applies to hardware devices in the QFX Series.
167Copyright © 2011, Juniper Networks, Inc.
Chapter 17: Installation and Maintenance Safety Information
To Next Page
Loading...
Need help?
General
