Juniper EX2200 Series - Connecting and Configuring an EX Series Switch (CLI Procedure)

}
}
ethernet-switching-options {
storm-control {
interface all;
}
}
Related
Documentation
Configuration Files Terms•
• Connecting and Configuring an EX Series Switch (CLI Procedure) on page 129
• Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 131
• Understanding Configuration Files for EX Series Switches
• EX2200 Switches Hardware Overview on page 3
Connecting and Configuring an EX Series Switch (CLI Procedure)
There are two ways to connect and configure an EX Series switch: one method is through
the console using the command-line interface (CLI) and the other is using the J-Web
interface.
NOTE: EX2200-24T-DC switches, EX2200-C switches, EX3300 switches,
and EX6200 switches do not support switch connection and configuration
through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the ezsetup script, the switch must have the factory default
configuration as the active configuration. If you have configured anything on
the switch and want to run ezsetup, revertto the factory default configuration.
See Reverting to the Default Factory Configuration for the EX Series Switch.
Before you begin connecting and configuring an EX Series switch through the console
using the CLI:
•
Set the following parameter values in the console server or PC:
•
Baud rate—9600
•
Flow control—None
•
Data—8
•
Parity—None
129Copyright © 2011, Juniper Networks, Inc.
Chapter 11: Performing Initial Configuration