Juniper EX2300 Series - Page 192

NOTE: To revert a member switch of a Virtual Chassis to the factory-default conguraon,
disconnect the cables connected to the VCPs to avoid aecng Virtual Chassis conguraon
parameters (member ID, primary-role priority, and seng of VCP uplinks) on other members (see
Disconnect a Fiber-Opc Cable ).
To revert to the factory-default conguraon by using the Factory Reset/Mode buon:
1. Press the Factory Reset/Mode buon for 10 seconds. The switch transions into factory-default
conguraon, the console displays comming factory default conguraon, and the Link/Acvity
LED on the RJ-45 network ports and the uplink ports is lit steadily in green color.
2. Press the Factory Reset/Mode buon for 10 more seconds. The switch transions into inial setup
mode, the console displays comming ezsetup cong, and the Link/Acvity LED on the RJ-45
network ports and the uplink ports blink in green color.
The Factory Reset/Mode buon is enabled by default. You can disable the buon using the CLI.
To disable the Factory Reset/Mode buon, run the commands:
1. [edit]
user@switch# set chassis config-button no-clear
2. [edit]
user@switch# commit
To enable the Factory Reset/Mode buon, run the commands:
1. [edit]
user@switch# delete chassis config-button no-clear
2. [edit]
user@switch# commit
RELATED DOCUMENTATION
Connecng and Conguring an EX Series Switch (CLI Procedure) | 171
Connecng and Conguring an EX Series Switch (J-Web Procedure) | 175
Understanding Conguraon Files
183