Juniper EX2300 Series Hardware Guide

Table 20: Site Electrical Wiring Guidelines
Site Wiring
Factor
Guidelines
Signaling
limitaons
If your site experiences any of the following problems, consult experts in electrical surge
suppression and shielding:
• Improperly installed wires cause radio frequency interference (RFI).
• Damage from lightning strikes occurs when wires exceed recommended distances or pass
between buildings.
• Electromagnec pulses (EMPs) caused by lightning damage unshielded conductors and
electronic devices.
Radio
frequency
interference
To reduce or eliminate RFI from your site wiring, do the following:
• Use a twisted-pair cable with a good distribuon of grounding conductors.
• If you must exceed the recommended distances, use a high-quality twisted-pair cable with
one ground conductor for each data signal, when applicable.
Electromagnet
ic
compability
If your site is suscepble to problems with electromagnec compability (EMC), parcularly
from lightning or radio transmiers, seek expert advice.
Some of the problems caused by strong sources of electromagnec interference (EMI) are:
• Destrucon of the signal drivers and receivers in the device
• Electrical hazards as a result of power surges conducted over the lines into the equipment
Rack Requirements
You can mount the device on two-post racks or four-post racks.
Rack requirements consist of:
• Rack type
• Mounng bracket hole spacing
• Rack size and strength
63

Juniper EX2300 Series Specifications

General

Software	Junos OS
Model	EX2300
Ports	24 or 48 10/100/1000BASE-T ports
Uplinks	4 x 1GbE/10GbE SFP+/SFP uplinks
Power Supply	Internal or external power supply options
Rack Units	1U
PoE/PoE+ Ports	Available on some models (EX2300-C and EX2300)
Operating Temperature	0° to 45°C
Input Voltage	100 to 240 VAC
Layer 3 Features	RIP, OSPF, VRRP
Layer 2 Features	VLAN, STP, RSTP, MSTP, LACP
Security Features	802.1X, DHCP snooping
Management	CLI, Web UI, SNMP