Docu-No.: 0590020601-EN Rev. 1.6.0 Page 57
Programming Reference 1
HCU / LSR loader set-up 1.10
TIME [sec]
Active Time
Remaining time in the current active cycle.
Input range: Display only
STATUS
Loader Status
Display of the current status of the HCU. Normal OK.
ALARM HCU has an alarm.
PROG HCU in programming mode.
REC FULL Receiver is full.
BUFFER FULL Buffer hopper is full.
HCU COM FAIL Serial communication between KCM and HCU
interrupted.
Input range: Display only
PARAM NUM
Only in KSU-II/KCM
Input of the parameter number. The name and value represented by
the parameter number will be displayed under the variables PARAM
DESC and PARAM VALUE respectively.
Input range: see section 5.3 and manual 0290023601.
PARAM VALUE
Parameter Value
Input of the desired value for the selected PARAM NUM.
input range: see section 5.3 and manual 0290023601.
PARAM NAME
Parameter Name
Display of the parameter name selected with PARAM NUM.
Input range: Display only
See section 5.3 and manual 0290023601.
Parameter
Definition
Table page 2 of 2
To Next Page
Loading...
Need help?
General
