K-TRON K-Vision User Manual

Docu-No.: 0590020601-EN Rev. 1.6.0 Page 59
Programming Reference 1
System setup (only KSU-II/KCM). 1.11
1.11.2 SW Version Submenu
Note:
• Before calling K-Tron service, have the SW version numbers
available for your system.
BAUD RATE
Displays baud rate selections when K-Port2 is set to KSC/K-Vision.
Choices are: 9600, 19200, 38400
CONF MODE
Input of the protocol for the following: Diag, KMB, Config, User IF
Input range:see above
Default: User IF
Notes:
• Select <KMB> for ParamStore.
• Select <Config> for SmartConfig activities.
• Select <User IF> for PC access to KCM parameter data via the
Conf port.
• Select <Diag> is used for diagnostic trace functions and for
loading a language file.
Parameter
Definition
Table page 2 of 2
Parameter
Definition
SELECT ONE
Selection of the Hardware
SW#
The application software part number and revision.
HW#
The hardware number and revision.
SER#
The serial number.

K-TRON K-Vision Specifications

General

Brand	K-TRON
Model	K-Vision
Category	Control Panel
Language	English