Kamstrup MULTICAL 403 - Page 35

MULTICAL® 403
Kamstrup A/S · Technical description · FILE100000166_B_EN-55121689_M1_07.2023
35
The registers which are connected to the pulse inputs can be read in the meter’s ”TECH loop”, in ”USER loop”
(depending on selected DDD-code) and via data communication. Further, it is possible to pre-set the counter values
of the two pulse inputs at the values of the connected meters at the time of commissioning. This can either be done
via the meter’s ”SETUP loop” or via METERTOOL HCW.
Input A
Input B
Meter count
Meter count
Meter No. A
Meter No. B
L/imp. of A
Wh/imp. of B
Yearly date
Yearly date
Yearly data
Yearly data
Monthly date
Monthly date
Monthly data
Monthly data