Kaypro 2 - 05-1.TIFF

5.0 aJASSIS
5.1 aJASSIS H<XD ImDlAL (EX.CEPT KAYPRO RffiIE)
1. Turn 0 ff the machine.
2. Disconnect AC power by unplugging the power cord from wall outlet.
3. Remove the ten screws from the chassis haJdi there are two on top
and fuur on each side.
4. Renove the haJd fran the chassis.
aJASSIS H<XD ~
1. lDwer the hood onto the unit.
2. Align the two holes on top 0 f the hood with those on top 0 f the
chassis.
3. Insert the two flat-head screws into the holes on the top of the
chassis and start them, but do rot tighten them yet.
4. Insert the eight round-head screws, fuur on each side, and start
them.
5. Tighten each screw securely.
5-1