Keithley 2750 User Manual

Model 2750 Multimeter/Switch System User’s Manual SCPI Signal Oriented Commands 13-3
CONFigure:<function> [<rang>], [<res>], [<clist>]
CONFigure:VOLTage[:DC] [<rang>], [<res>], [<clist>] Configure DCV
CONFigure:VOLTage:AC [<rang>], [<res>], [<clist>] Configure ACV
CONFigure:CURRent[:DC] [<rang>], [<res>], [<clist>] Configure DCI
CONFigure:CURRent:AC [<rang>], [<res>], [<clist>] Configure ACI
CONFigure:RESistance [<rang>], [<res>], [<clist>] Configure Ω2
CONFigure:FRESistance [<rang>], [<res>], [<clist>] Configure Ω4
CONFigure:FREQuency [<rang>], [<res>], [<clist>] Configure FREQ
CONFigure:PERiod [<rang>], [<res>], [<clist>] Configure PERIOD
CONFigure:TEMPerature [<clist>] Configure TEMP
CONFigure:CONTinuity [<clist>] Configure CONT
Parameters <rang> = Range parameter for the specified function. For example, for
DCV, range parameter value 10 selects the 10V range. See
the “NOTES” that follow Table 13-1 for additional information.
<res> = 0.1 i.e., 100.0 V (3H digits)
0.01 i.e., 10.00 V (3H digits)
0.001 i.e., 1.000 V (3H digits)
0.0001 i.e., 1.0000 V (4H digits)
0.00001 i.e., 1.00000 V (5H digits)
0.000001 i.e., 1.000000 V (6H digits)
The resolution of the <res> parameter value and the selected range
sets the number of display digits. As shown above, with the 100V
range selected and <res> = 0.1, a 100V reading will be displayed
as 100.0 V (3H digits).
The display will default to 3H digits when using parameter values
that attempt to set the display below 3H digits. For example, a 10V
reading using <res> = 0.1 for the 10V range is displayed as 10.00
V, not 10.0 V.
A command using parameter values that attempt to set the dis-
play above 7H digits is ignored, and generates error -221 (set-
tings conflict error).
The <res> parameter is ignored when a <clist> is included in
the command string. Resolution for the scanlist channel(s) is
determined by the present setting for the specified function and
by the present resolution setting for the specified function.
See the “NOTES” that follow Table 13-1 for additional infor-
mation.
<clist> = Channel(s) in the scanlist to be configured. When the channel
list parameter (<clist>) is included, the present instrument set-
tings are not affected. Instead, the channel(s) in the <clist> for
the specified function is configured. See the “NOTES” that fol-
low Table 13-1 for additional information.
2750-900-01.book Page 3 Wednesday, August 3, 2011 7:56 AM

Keithley 2750 Specifications

General

Brand	Keithley
Model	2750
Category	Switch
Language	English