To Next Page

To Previous Page

1-26 Getting Started Model 2750 Multimeter/Switch System User’s Manual

NOTE When using the front panel input terminals, the INPUT switch must be in the

“F” (out) position. The INPUT switch is located on the right side of the front

panel near the input terminals. When using a switching module, the switch must

be in the “R” (in) position.

Basic DMM measurements — front panel inputs

NOTE See Section 3 for details on basic DMM operation.

The Model 2750 is shipped from the factory to power-up to factory defaults. The instru-

ment powers up to a setup that continuously measures DC volts. Some of the default set-

tings for the DCV function include auto range enabled, 6½-digit resolution, filter enabled,

and slow reading rate. These settings provide a good starting point and in many cases, do

not need to be changed.

“Starting-point” default settings are also provided for the other measurement functions.

Therefore, to perform basic measurements, simply select the desired function, and

“tweak” the setup (range, rate, filter, digits, etc.) as required.

For remote programming, the instrument is typically used in a non-continuous measure-

ment mode. In this mode, the user (via remote command programming) specifies the num-

ber of measurements to perform. *RST defaults place the instrument in a non-continuous

measurement mode. Most of the other settings for factory and *RST defaults are the same.

For remote programming, the following command is used to select function.

NOTE Items in brackets ([]) are optional and do not need to be included. Upper case

characters are required. Lower case characters are optional and need not be

included.

[SENSe[1]]:FUNCtion <func> ' Select measurement function.

<func> = 'VOLTage[:DC]' DCV

'VOLTage:AC' ACV

'CURRent[:DC]' DCI

'CURRent:AC' ACI

'RESistance' Ω2

'FRESistance' Ω4

'FREQuency' FREQ

'PERiod' PERIOD

'TEMPerature' TEMP

Each function can have its own unique setup configuration (i.e., range, digits, speed, etc.).

For example, the following command words select range and digits:

RANGe[:UPPer] <n> ' Specify expected reading.

RANGe:AUTO <b> ' Enable (ON) or disable (OFF) auto range.

DIGits ' Set display resolution; 3.5, 4.5, 5.5 or 6.5 (digits).

2750-900-01.book Page 26 Wednesday, August 3, 2011 7:56 AM

Keithley 2750 User Manual

Other manuals for Keithley 2750