To Next Page

To Previous Page

15-2 SCPI Reference Tables Model 2750 Multimeter/Switch System User’s Manual

Reference tables

Table 15-1 through Table 15-10 summarize the commands to operate the Model 2750 and

Model 7700 switching module.

NOTE The commands listed in the following tables pertain to operation of the Model

2750 and the Model 7700 switching module. For commands that are unique to

operation of other switching modules, refer to the packing list that was included

with the module.

Table 15-1 — CALCulate command summary

Table 15-2 — DISPlay command summary

Table 15-3 — FORMat command summary

Table 15-4 — ROUTe command summary

Table 15-5 — SENSe command summary

Table 15-6 — STATus command summary

Table 15-7 — SYSTem command summary

Table 15-8 — TRACe command summary

Table 15-9 — Trigger command summary

Table 15-10 — UNIT command summary

General notes:

• Brackets ([ ]) are used to denote optional character sets. These optional characters

do not have to be included in the program message. Do not use brackets in the pro-

gram message.

• Angle brackets (< >) are used to indicate parameter type. Do not use angle brackets

in the program message.

• The Boolean parameter (<b>) is used to enable or disable an instrument operation.

1 or ON enables the operation, and 0 or OFF disables the operation.

• Upper case characters indicate the short-form version for each command word.

• Default Parameter — Listed parameters are both the *RST and SYSTem:PRESet

defaults, unless noted otherwise. Parameter notes are located at the end of each

table.

• Ref — The reference column indicates where to find detailed information on the

command(s).

• SCPI — A checkmark (✓) indicates that the command and its parameters are SCPI

confirmed. An unmarked command indicates that it is an SCPI command, but does

not conform to the SCPI standard set of commands. It is not a recognized

command by the SCPI consortium. SCPI confirmed commands that use one or

more non-SCPI parameters are explained by notes.

2750-900-01.book Page 2 Wednesday, August 3, 2011 7:56 AM

Interface	GPIB, RS-232, Ethernet
Switching Speed	Up to 500 channels/second
Maximum Voltage	300V
Operating Temperature	0°C to 50°C
Measurement Functions	DCV, ACV, DCI, ACI, 2-wire Resistance, 4-wire Resistance, Frequency, Temperature
Resolution	6.5 digits
Current	1A
Maximum Current	1A

Keithley 2750 User Manual

Other manuals for Keithley 2750