Keithley 2750 User Manual

15-6 SCPI Reference Tables Model 2750 Multimeter/Switch System User’s Manual
Table 15-2
DISPlay command summary
Command Description
Default
parameter Ref SCPI
DISPlay (see Note) Sec 1
[:WINDow[1]] ✓
:TEXT Path to control user text messages. ✓
:DATA <a> Define ASCII message “a”
(up to 12 characters).
(none) ✓
:DATA? Query text message. ✓
:STATe <b> Enable or disable message mode. OFF ✓
:STATe? Query text message state. ✓
:ENABle <b> Enable or disable the front panel display. OFF ✓
:ENABle? Query state of the display. ✓
Note: *RST and SYSTem:PRESet have no effect on commands in this subsystem. The listed defaults are power-on defaults.
Table 15-3
FORMat command summary
Command Description
Default
parameter Ref SCPI
FORMat Sec 14
[:DATA] <type>
[,<length>]
Select data format (ASCii, SREal, or DREal). ASCii
[:DATA]? Query data format. ✓
:ELEMents <item list> Specify data elements (READing, CHANnel,
UNITs, RNUMber, TSTamp, and LIMits).
(see Note) ✓
:ELEMents? Query data elements. ✓
:BORDer <name> Select binary byte order (NORMal or
SWAPped).
SWAPped ✓
:BORDer? Query byte order. ✓
Note: The SYSTem:PRESet and *RST default is READ, UNIT, RNUM, and TST.
2750-900-01.book Page 6 Wednesday, August 3, 2011 7:56 AM

Keithley 2750 Specifications

General

Interface	GPIB, RS-232, Ethernet
Switching Speed	Up to 500 channels/second
Maximum Voltage	300V
Operating Temperature	0°C to 50°C
Measurement Functions	DCV, ACV, DCI, ACI, 2-wire Resistance, 4-wire Resistance, Frequency, Temperature
Resolution	6.5 digits
Current	1A
Maximum Current	1A