Model 2750 Multimeter/Switch System User’s Manual SCPI Reference Tables 15-7
Table 15-4
ROUTe command summary
Command Description
Default
parameter Ref SCPI
ROUTe
:MONitor <clist> Specify one channel to be monitored. Sec 7
:STATe <b> Enable or disable channel monitoring. OFF
:STATe? Query state of channel monitoring.
:DATA? Returns the most recent monitor reading.
:POINts <NRf> For a monitor scan, specify number of chan-
nels
to scan (2 to 110000).
(Note 1)
:POINts? For a monitor scan, query number of channels
to
scan.
:MONitor? Query the channel to be monitored.
:CLOSe <clist> Close the one specified channel (all others will
open).
Sec 2
:STATe? <clist> Query closed channels in specified list;
1 = closed.
:ACONfigure <b> Enable or disable auto-configure. (Note 2)
:ACONfigure? Query state of auto-configure.
:COUNt? <clist> Query closure count for specified channels. Sec 2
:INTerval
<NRf>
Set count update interval in minutes (10 to
1440).
(Note 3)
:INTerval? Query relay count update interval.
:CLOSe? Returns a <clist> of closed channels.
:OPEN:ALL Open all channels. Sec 2
:MULTiple Path to control multiple channels: Sec 2
:OPEN <clist> Open channel(s) specified in list. Unlisted
channels not affected.
:CLOSe <clist> Close channel(s) specified in list
4
. Unlisted
channels not affected.
:STATe? <clist> Query closed channels in specified list;
1 = closed.
:CLOSe? Return list of all closed channels.
2750-900-01.book Page 7 Wednesday, August 3, 2011 7:56 AM
To Next Page
Loading...
Need help?
General
