Keithley 2750 - Page 366

Model 2750 Multimeter/Switch System User’s Manual SCPI Reference Tables 15-19
Table 15-6
STATus command summary
Command Description
Default
parameter Ref SCPI
STATus (Note 1) Sec 11 ✓
:MEASurement Path to control measurement event registers:
[:EVENt]? Read the event register. (Note 2)
:ENABle <NRf> Program the enable register. (Note 3)
:ENABle? Read the enable register.
:CONDition? Read the condition register.
:OPERation Path to control operation status registers: ✓
[:EVENt]? Read the event register. (Note 2) ✓
:ENABle <NRf> Program the enable register. (Note 3) ✓
:ENABle? Read the enable register. ✓
:CONDition? Read the condition register. ✓
:QUEStionable Path to control questionable status registers: ✓
[:EVENt]? Read the event register. (Note 2) ✓
:ENABle <NRf> Program the enable register. (Note 3) ✓
:ENABle? Read the enable register. ✓
:CONDition? Read the condition register. ✓
:PRESet Return status registers to default states. ✓
:QUEue Path to access error queue: ✓
[:NEXT]? Read the most recent error message. (Note 4) ✓
:ENABle <list> Specify error and status messages for queue. (Note 5) ✓
:ENABle? Read the enabled messages. ✓
:DISable <list> Specify messages not to be placed in queue. (Note 5)
:DISable? Read the disabled messages.
:CLEar Clears all messages from Error Queue.
Notes:
1. Commands in this subsystem are not affected by *RST and SYSTem:PRESet. The effects of cycling power, *CLS and
STATus:PRESet are explained by the following notes.
2. Event Registers: Power-up and *CLS — Clears all bits of the registers.
STATus:PRESet — No effect.
3. Enable Registers: Power-up and STATus:PRESet — Clears all bits of the registers.
*CLS — No effect.
4. Error Queue: Power-up and *CLS — Clears the Error Queue.
STATus:PRESet — No effect.
5. Enable/Disable Error Queue Messages: Power-up — Clears list of messages.
*CLS and STATus:PRESet — No effect.
2750-900-01.book Page 19 Wednesday, August 3, 2011 7:56 AM