Model 2750 Multimeter/Switch System User’s Manual SCPI Reference Tables 15-17
[SENSe[1]]
:FREQuency Path to configure frequency. Sec 3
:APERture <NRf>
[, <clist>]
Sets gate time for frequency
measurements in seconds (0.01 to 1.0).
1.0 Sec 4
:APERture? [<clist>] Query frequency gate time.
:DIGits <n> [, <clist>] Specify measurement resolution (4 to 7). 7 Sec 4
:DIGits? [<clist>] Query resolution.
:REFerence <n> [, <clist>] Specify reference (0 to 1.5e7). 0 Sec 5
:STATe <b> [, <clist>] Enable or disable reference. OFF
:STATe? [<clist>] Query state of reference.
:ACQuire [, <clist>] Use input signal as reference.
:REFerence? [<clist>] Query reference value.
:THReshold Path to select the threshold voltage range: Sec 3 ✓
:VOLTage ✓
:RANGe <n> [, <clist>] Select threshold range (0 to 1010). 10
:RANGe? [<clist>] Query threshold range.
:PERiod Path to configure period: Sec 3
:APERture <NRf>
[, <clist>]
Sets gate time for period measurements in
seconds (0.01 to 1.0).
1.0 Sec 4
:APERture? [<clist>] Query period gate time.
:DIGits <n> [, <clist>] Specify measurement resolution (4 to 7). 7 Sec 4
:DIGits? [<clist>] Query resolution.
:REFerence <n> [, <clist>] Specify reference (0 to 1). 0 Sec 5
:STATe <b> [, <clist>] Enable or disable reference. OFF
:STATe? [<clist>] Query state of reference.
:ACQuire [, <clist>] Use input signal as reference.
:REFerence? [<clist>] Query reference value.
:THReshold Path to select the threshold voltage range: Sec 3
:VOLTage
:RANGe <n> [, <clist>] Select threshold range (0 to 1010). 10
:RANGe? [<clist>] Query threshold range.
Table 15-5 (continued)
SENSe command summary
Command Description
Default
parameter Ref SCPI
2750-900-01.book Page 17 Wednesday, August 3, 2011 7:56 AM
To Next Page
Loading...
Need help?
General
