29
4
4
Features of your vehicle Windows
Power windows (if equipped)
The ignition switch must be in the
ON position for power windows to
operate.
Each door has a power window
switch that controls the door's win
-
dow. The driver has a power window
lock switch which can block the
operation rear passenger windows.
The power windows can be oper
-
ated for approximately 3 minutes
after the ignition key is removed or
turned to the ACC or LOCK position.
However, if the front doors open,
the power windows cannot be oper
-
ated within the 3 minutes period.
If the window cannot be close
because it is blocked by objects,
remove the objects and close the
window.
8hilst driving with the rear windows
down or with the sunroof (if
equipped) in an open (or partially
open position), your vehicle may
demonstrate a wind buffeting or
pulsation noise. This noise is a nor
-
mal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one
or both of the rear windows down,
partially lower both front windows
approximately one inch. If you expe
-
rience the noise with the sunroof
open, slightly reduce the size of the
sunroof opening.
Do not install any accessories in the
area of windows. It may impact jam
protection.
Window opening and closing
The driver䳓s door has a master
power window switch that controls
all the windows in the vehicle.
Type A
To open or close a window, press
down or pull up the front portion of
the corresponding switch to the
first detent position ().
Type B - Auto up/down window (if
equipped)
Pressing or pulling up the power
window switch momentarily to the
second detent position (6) com
-
pletely lowers or lifts the window
To Next Page
Loading...
