Features of your vehicle
1104
-ighting
䳜 8hen the road conditions are bad
such as being wet or covered with
snow.
䳜 8hen the front vehicle䳓s head
-
lamps are off but the fog lamps
on.
䳜 8hen a vehicle suddenly appears
from a curve.
䳜 8hen the vehicle is tilted from a
flat tyre or being towed.
䳜 8hen Lane keeping Assist warn
-
ing light illuminates. (if equipped)
䳜 Do not place any accessories,
stickers or tint the windscreen.
䳜 Have the windscreen glass
replaced from an authorised
dealer.
䳜 Do not remove or impact related
parts of High Beam Assist.
䳜 Be careful that water doesn䳓t get
into High Beam Assist unit.
䳜 Do not place objects on the dash
-
board that reflects light such as
mirrors, white paper, etc. The
function may malfunction if sun
-
light is reflected.
䳜 At times, High Beam Assist may
not work properly, always check
the road conditions for your
safety. 8hen the function does
not operate normally, manually
change between the high beam
and low beam.
Turn signals and lane change sig
-
nals
Type A
Type B
The ignition switch must be on for
the turn signals to function. To turn
on the turn signals, move the lever
up or down (A).
The green arrow indicators on the
instrument panel indicate which
turn signal is operating. They will
selfcancel after a turn is completed.
If the indicator continues to flash
after a turn, manually return the
lever to the O (OFF) position.
To Next Page
Loading...
