133
5
5
Driving your vehicle Smart Cruise Control (SCC)
To adjust the sensitivity of smart
cruise control
The sensitivity of vehicle speed
when following the front vehicle to
maintain the set distance can be
adjusted.Go to the 'User settings →
Driver assistance → SCC reaction →
Fast/Normal/Slow' on the LCD dis
-
play. You may select one of the
three stages you prefer.
SCC Reaction
䳜 Fast:
Vehicle speed following the front
vehicle to maintain the set distance
is faster than normal speed.
䳜 Normal:
Vehicle speed following the front
vehicle to maintain the set distance
is normal
䳜 Slow:
Vehicle speed following the front
vehicle to maintain the set distance
is slower than normal speed.
Function operating
Operating conditions
Smart Cruise Control will operate
when the following conditions are
satisfied.
Basic function
䳜 The gear is in D (Drive)
䳜 The driver's door is closed
䳜 Your vehicle speed is within the
operating speed range 10~180
km/h (~110 mph)
䳜 ESC (Electronic Stability Control),
TCS (Traction Control System) or
ABS is on
䳜 ESC (Electronic Stability Control),
TCS (Traction Control System) or
ABS is not operating
䳜 Engine rpm is not in the red zone
䳜 Forward Collision-Avoidance
Assist brake control is not operat
-
ing
䳜 3emote Smart Parking Assist
brake control is not operating
䳜 ISG is not operating
Overtaking Acceleration Assist
Overtaking Acceleration Assist will
operate when the turn signal indica
-
tor is turned on to the left (left-
hand drive) or turned on to the right
(right-hand drive) whilst Smart
Cruise Control is operating, and the
following conditions are satisfied:
䳜 Your vehicle speed is above 60
km/h (40 mph)
䳜 The hazard warning flasher is off
䳜 A vehicle is detected in front of
your vehicle
䳜 Deceleration is not needed to
maintain distance with the vehicle
in front
䳜 8hen the turn signal indicator is
turned on to the left (left-hand
To Next Page
Loading...
