21
3
3
Safety features of your vehicle Seat belts
Pull the metal tab (3) and insert it
(3) into the buckle (4). There will be
an audible 䳖click䳗 when the tab locks
into the buckle. Make sure the belt is
not twisted. When using the rear
centre seat belt the buckle with the
䳖C&NT&3䳗 mark must be used.
To release the seat belt:
The seat belt is released by pressing
the release button (1) on the locking
buckle. When it is released, the belt
should automatically draw back into
the retractor.
If this does not happen, check the
belt to be sure it is not twisted, then
try again.
Stowing the rear seat belt
The rear seat belt buckles can be
stowed in the pocket between the
rear seatback and cushion when not
in use.
Pre-tensioner seat belt (if
equipped)
Your vehicle is equipped with pre-
tensioner seatbelts at the front and
rear outboard seating positions. The
purpose of the pre-tensioner is to
To Next Page
Loading...
