Maintenance
1087
-ight bulbs
7. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
8. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assem
-
bly and turn the socket clockwise.
. Install the rear combination lamp
assembly to the body of the vehi
-
cle.
Tail lamp (inside) bulb replacement
1. Open the tailgate.
2. 3emove the service cover.
3. 3emove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
4. 3emove the bulb from bulb-
socket by pulling it out.
. Insert a new bulb by inserting it
into the bulb-socket.
6. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assem
-
bly and turn the socket clockwise.
7. Install the service cover by putting
it into the service hole.
To Next Page
Loading...
