Features of your vehicle
1304
Manual climate control system
speed as the air conditioning
compressor cycles. This is a nor
-
mal system operation character
-
istic.
䳜 Use the air conditioning system
every month only for a few min
-
utes to ensure maximum system
performance.
䳜 8hen using the air conditioning
system, you may notice clear
water dripping (or even puddling)
on the ground under the passen
-
ger side of the vehicle. This is a
normal system operation charac
-
teristic.
䳜 Operating the air conditioning
system in the recirculated air
position provides maximum cool
-
ing, however, continual operation
in this mode may cause the air
inside the vehicle to become stale.
䳜 During cooling operation, you may
occasionally notice a misty air
flow because of rapid cooling and
humid air intake. This is a normal
system operation characteristic.
Activate upon Washer Fluid Use (if
equipped)
To prevent the odor from entering
to inside the vehicle, the ventilation
system changes to 3ecirculated Air
Mode for a whilst when the wind
-
screen washer fluid sprayed. How
-
ever, at low outside temperature, to
prevent from windscreen fogging,
the system continues to outside air
mode.
System setting
1. ENGINE STA3T/STOP button is On
or ignition switch ON.
2. Select Floor-Level ( ) air flow
direction by pressing Mode Selec
-
tion button.
3. 8ith pressing Air Conditioning
button, press the 3ecirculated Air
button more than 4 times within
2 seconds.
4. If the system is set up, the indica
-
tor on 3ecirculated Air button will
blinks 6 times.
System cancellation
1. ENGINE STA3T/STOP button is On
or ignition switch ON.
2. Select Floor-Level ( ) air flow
direction by pressing Mode Selec
-
tion button.
3. 8ith pressing Air Conditioning
button, press the 3ecirculated Air
button more than 4 times within
2 seconds.
4. If the system is cancelled, the
indicator on 3ecirculated Air but
-
ton will blinks 3 times.
Activation on washer fluid is acti
-
vated when you select 䳒Settings →
Vehicle → Climate → 3ecirculate Air
→ Activate upon 8asher Fluid Use䳓
from the Settings menu to turn on
Activate upon 8asher Fluid Use and
deselect to turn off the function.
To Next Page
Loading...
