Driving your vehicle
925
Blind-Spot Collision Warning (BCW)
䳜 Select 䳒Late䳓 for 8arning timing
when traffic is light and when
driving speed is slow.
Function operation
Function warning
Vehicle detection
䳜 To warn the driver a vehicle is
detected, the warning light on the
outside rearview mirror and will
illuminate
䳜 The function will operate when
your vehicle speed is above 20
km/h (12 mph) and the speed of
the vehicle in the blind spot area is
above 10 km/h (7 mph).
Collision warning
䳜 Collision warning will operate
when the turn signal is turned on
in the direction of the detected
vehicle.
䳜 If 䳒8arning only䳓 is selected from
the Settings menu, the collision
warning will operate when your
vehicle approaches the lane the
blind spot vehicle is detected.
䳜 To warn the driver of a collision,
the warning light on the outside
rearview mirror will blink.
䳜 8hen the turn signal is turned off
or you move away from the lane,
the collision warning will be can
-
celled and the function will return
to vehicle detection state.
䳜 The detecting range of the rear
corner radar is determined by the
standard road width, therefore,
on a narrow road, the function
may detect other vehicles in the
next lane and warn you. In con
-
trast, on a wide road, the function
may not be able to detect a vehi
-
cle driving in the next lane and
may not warn you.
䳜 8hen the hazard warning light is
on, the collision warning by the
turn signal will not operate.
Take the following precautions
when using Blind-Spot Safety sys
-
tem:
䳜 For your safety, change the Set
-
tings after parking the vehicle at a
safe location.
䳜 If any other function䳓s warning
message is displayed or audible
warning is generated, Blind-Spot
Safety system䳓s warning mes
-
sage may not be displayed and
To Next Page
Loading...
